Evaluation Board TQ STK16XU

Your product was tested in the uVision simulator and on a sample hardware. We used the TQ STK16XU evaluation board.

Important: The delivered example starup code START167.A66 will not match all applications, evaluation boards, monitors, memory configurations etc. It can only be used as an example which needs to be changed to the needs of your project. We deliver the startup file with a deactivated bus configuration (BUSCON = 0). This will work fine in the simulator and together with the Phytek MM167 target monitor available in uVision with the GettingStarted project. If you want to flash your application to the TQ board and do not use a monitor taking care of the BUSCON etc., you might also need to change your startup file.

To connect the TQM16XU to debug the GettingStarted example, please follow these steps:

connect the serial cable with your PC as illustrated below
set all DIP switches off
set the 'boot' switch to right (pointing away from the CPU), so it will not boot from flash

In Keil uVision switch the debug mode to the C166 monitor and verify the correct settings.

You need to select the right COM port for your machine.

In the Blinky model the port 2 is used to set the output LEDs. On the TQ board the LEDs are connected to port 2, so you must see a blinking LED after starting execution of GettingStarted with the deployed Blinky files.

If you experience any problems with the monitor, e.g. after pressing run the connection gets lost, first check if your memory layout fits the monitor and if you reserved the correct memory areas for the monitor and vectors.

More info can be found on the TQ Website.